Angel Care AC401 Owner's Manual download pdf (Page 11)

HOW TO OPERATE YOUR ANGELCARE

MONITOR

Charger adapter

socket

STEP 1

• Connect the long sensor pad cord into the nursery unit.

• Insert 4 AAA regular batteries (not included) into nursery unit (for battery

backup in case of power failure).

• Connect AC adapter to nursery unit and plug adapter into an electrical

outlet in the baby’s room.

• After both units are properly installed you may adjust the sensor pad

sensitivity level. The sensitivity dial shows the level 1 to 5, where 1 is less

sensitive and 5 very sensitive. It is preset between level 2,5 and 3. Should

there be a false alarm, increase the sensitivity by a half level during testing

until it works perfectly for your mattress and bed size.

• Insert 4 AAA NIMH rechargeable batteries (included) into Parent Unit.

NEVER use regular alkaline batteries, they may explode.

• Connect AC adapter to Parent Unit charger and plug adapter into an

electrical outlet. Let charge for 15 continuous hours before using the

monitor for the first time.

Charger adapter

socket

Sensor pad cord

socket

Adapter socket

Sensor pad

sensitivity dial

1 sensor pad 2 sensor pads

POSITION OF SENSOR PAD UNDER MATTRESS

Crib center Crib center

•Position the sensor pad as shown above. Make sure the printed side faces up. Do NOT place any bedding between the mattress

and the sensor pad.

•Secure the sensor pad cord to crib using a tie wrap. Run the cord on the floor to ensure it is out of the baby’s reach.

•The Sensor Pad must rest on a completely flat and firm surface. If the crib has a spring or slat base, place a hard board between

the crib base and the Sensor Pad measuring at least 13” x 13” (33x33 cm) and 1/4 inch (6 mm) thick. Make sure the sensor

pad’s cord passes underneath the mattress as shown above.

• The sensor pad works with all baby bed sizes and all mattresses, except memory foam mattresses.You will have to test your

sensor pad on STEP 13.

• Once you are done using the Sensor Pad, please remove it from the baby’s crib and store it away.

•The Angelcare Sensor Pad feature is not designed for use with adults, children or infants older than 24 months.

IMPORTANT

Keep at

least 1m

(39 inches)

apart

Sensor Pad(s) 1 or 2

INSTALLATION OF THE SENSOR PAD UNDER THE MATTRESS

STEP 2

INSTALLATION OF THE NURSERY UNIT

Battery

compartment

STEP 3

INSTALLATION OF THE PARENT UNIT

Battery

compartment

(On some models)

WARNING

STRANGULATION HAZARD - Children have STRANGLED in cords. Keep the adapter cords and

sensor pad cord out of the reach of children. Do not put the Nursery Unit inside a crib or play

yard. Because of the serious strangulation risk to infants and toddlers, parents and caregivers

should never place the nursery unit within 3 feet (1 meter) of a crib. NEVER use extension

cords with AC adapters. ONLY use the AC adapters provided.

AC401 NA 13 12 2012_AC401inter 042008 12-12-19 8:48 AM Page 11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 49 50

Comments to this Manuals

No comments

Angel Care AC401 Owner's Manual Page 11

Comments to this Manuals